Counterweight Alignment Tool

This plastic guide fits over the end of the UF14N eccentric to properly align the UF19 counterweights. This is a 3d printed item, if you would like to print it yourself the model is linked below...

$2.00

Item # UF14T

Edger Pad Adjust Removal Tool

For removing and installing edger pads. This adjustable wrench can be adjusted to fit all edger pads...

$46.70

Item # E20A

Commutator Stone, 1/4 x 1/2

Brush seater/commutator stone. To seat new brushes, run this stone over the surface of the commutator with the motor running. The abrasive from the stone will stick to the commutator, wearing down the brushes to match the shape of the commutator. Clean the commutator with compressed air to remove the abrasive when done...

$10.30 - $11.44

Item # SW05

Drift punch, 16 inch

For removing drum shafts from American 8 and American 12 drum sanders. Use this aluminum punch to drive the shaft out without damaging it. Always drive on the right side of the shaft to remove (the side without the pulley). There is a shoulder on the shaft between the pulley side bearing and the drum which prevents the shaft from going through the drum that way...

$27.67

Item # SW04

Drum Puller for EZ8 Floor Sander

For removing drums from EZ8, Classic 8 and Apollo 8 Floor Sanders. Fits 8 inch wide drums 6 inch in diameter. Has a hardened 5/8-18 screw that can be turned with a 15/16 wrench or socket. For larger Floor Sanding drums use part number SW09...

$78.71

Item # EZPUL

Floor Sander Drum Puller 8 10 12

For removing drums from Floor Sander belt sanders. This large puller fits 8, 10 or 12 inch drums up to 7.5 inch diameter. Has a hardened 5/8-18 screw that can be turned with a 15/16 wrench or socket. We also have a smaller puller for removing drums on EZ8 sanders (EZPUL)...

$102.74

Item # SW09

Spanner Wrench

Spanner wrench for UFO clutch. You will need this to adjust the UF92 Spanner Nut when working on a UFO clutch...

$20.18

Item # UF100

Drum Puller Parts

Replacement parts for drum pullers..

Item # Puller

Paper Wrench

Thick head 7/16 wrenches for drum sander paper clamps. Sold by the piece, 2 required...

$16.72

Item # SW01

Setting Fixture (level tool)

Level tool for the Hummel. Use this tool to level the wheel to the frame of the machine. If you are installing a new drum this will level the drum to the floor or make a good starting point to have the machine level. If your drum is old the drum could be worn and may not be square to the machine and will need leveled by eye. Hummel Leveling Tool..

$66.55

Item # HS233

Leveling Tool

Level tool for KT Taurus and NT8 as well as Bona Belt HD. Use this tool as a guide to set both wheels to the same height. This will provide a good starting point at close to level; additional adjustment may be required to get the drum perfectly level...

$21.96

Item # TS179

Socket, Drum Removal 12mm

For removing drum bolts on KT Taurus and NT8, as well as Bona Belt HD machines. The drum retainer bolt on these machines is left hand thread, so turn clockwise to remove...

$22.72

Item # TS03